|
Scorpion S-3008 / SII-3008 Motor Shaft
The Scorpion S-30mm series of motors are built with 5mm hardened steel shafts that will last through countless hours of flying fun, but occasionally, on a "Less than Perfect" landing, you may bend or break one. For these occasions, we offer factory replacement shafts for all the S-30mm Scorpion Motors. Our Motor Shaft Kits include an original equipment factory shaft with the setscrew key ways already cut, a new shaft retaining collar, and a replacement setscrew for the retaining collar.
The shaft for the S-3008 series airplane motors measures 5mm in diameter, and is 62.5mm in length. The shaft kit will also fit other brushless motors that require a 5mm shaft of this length. The shafts can be cut shorter with a Dremel tool and a cut-off wheel if necessary to fit other motors.
Note: The shafts in the Scorpion motors are a slight press fit into the aluminum front housing. The shafts will not just slide out when the setscrews are removed. They need to be pressed out in a bearing press, or in a drill press, with the front houshing of the motor supported in a block of wood to prevent warping the front housing.
|
|
All required fields are marked with a star (*). Click the 'Add To Cart' or 'Add To Wish List' button at the bottom of this form to proceed.
